As the opening date for Zotefoams’ new plant in Poland moves closer, Group CEO David Stirling provides answers to some FAQs about the choice of location and plans for opening the facility.
READ MORE
Zotefoams is pleased to announce renewed approval from the WRAS for specific grades in its AZOTE® foam range.
READ MORE
Following comprehensive testing to demonstrate compliance with the EU Commission Regulation No 10/2011, Plastazote has been selected as a lightweight alternative for protective seals for world-famous parmesan cheese.
READ MORE
As the opening date for Zotefoams’ new plant in Poland moves closer, Group CEO David Stirling provides answers to some FAQs about the choice of location and plans for opening the facility. Q: Why did you choose Poland as the location for Zotefoams’ third foam manufacturing site? A: Poland was a clear choice from the
read more
Zotefoams is pleased to announce renewed approval from the UK Water Regulations Advisory Scheme (WRAS) for specific grades in its AZOTE® polyolefin foams range, confirming their suitability for contact with potable water up to 50°C for domestic purposes. The re-certification confirms that Plastazote® grades from 15-70 kg/m3 in LDPE and 30-110 kg/m3 in HDPE, as
read more
In the heartland of North America’s automobile industry, Zotefoams will demonstrate how it can help manufacturers rise to the triple challenge of evolving technologies, higher safety standards and efficiency considerations through the light weight, consistency and compliance with standards of its AZOTE® and ZOTEK® foam ranges.
read moreHigh quality polyolefin foams from differing base polymers but all manufactured using the same unique nitrogen expansion process route.
A range of high performance foams manufactured from fluoropolymers, engineering polymers and specialty elastomers.
An advanced insulation system designed to meet the standards required for clean process manufacture, improve cost efficiency and eliminate risk.
A patented technology that provides unique design flexibility and cost savings opportunities. An extruded part will perform like solid plastic but will typically use 15-20% less material. MuCell® is a registered trademark of Trexel, Inc.
